Panasonic
Philips Sonicare repair: Loud rattling noise, Head loose
Philips Sonicare repair: Loud rattling noise, Head loose
#Philips #Sonicare #repair #Loud #rattling #noise #loose
“Loiez”
I thought I’ll make a ‘short’ tutorial of fixing the Philips Sonicare .. well it got a bit longer, but I hope I can help anyone that sturggles to open or repair it 🙂
The Model seen in the Video is the “Philips Sonicare ProtectiveClean 5100” – Model number HX684A.
The common, well known…
source
To see the full content, share this page by clicking one of the buttons below |
Helped me fix two. The wires that he is so careful that attach to the head are to the sensor that reads how many time you used your toothbrush head. So if you break them it’s not the end of the world. You can still you it. You just have to manually decide when to change your toothbrush head.
Man, this was awesome. I kept dissasembling mine with you, and it was nice, straightforward and revealed a lot of tootbrush secrets. Great job. Thanks a lot!
Hi, did you seen method to use the glue gun to remove bottom cap?
I did try your method but sadly I broke the housing.
Wonderful video and oh-so helpful! Thanks for creating and sharing.
Will the seal work which water may enter from the top tip? Just curious.🙏
Thank you it worked great!! It’s like new again!!
Awesome! Thanks Man!!
It would have been great if you could have moved the camera 6 inches down anf 3 to the right for the first half of the video. Everything important happened JUST OFF CAMERA to the bottom right. It was like watching a magic show where they show you what happened but not HOW it happened.
i came here to fix my toothbrush, but i got my vision destroyed instead. Focus is tragic. Content is great.
Thank you!
Use a thin screw driver.
If you keep the finger on the phone screen to focus WHILE ALREADY RECORDING it locks in focus for the entire duration.
Thanks for that Video! It helped me fixing mine with the same top screw issue.
Tnx for the video, managed to open it up just to realize that it was broken right around the screw head.
Thanks, you showed me that I HATE THIS FRICKLY SHIT
Any ideas on if this has a sensor to turn lights on when moved?
Have one that looks like a techno rave sitting on the counter.
I hope an easy loose wire to solder.
Any other ideas to cause random light turn ons and flickering when not in use?
Consider using feeler gauges to gap the magnet. Used in vehicle applications but might fit for this.
Thanks , you saved me from spending for a new one
Thanks for video… My sonicare loose a screw in head which make a rattling noise.. I manage to fix it after your video 🎉. Thx
Thanks. You saved another toothbrush👍