Guide
Yamaha 360 Flat tracker top end disassembly
Yamaha 360 Flat tracker top end disassembly
#Yamaha #Flat #tracker #top #disassembly
“Dale Sweger”
In this video I remove the top end on the RT2 MX. Then I remove the clutch cover and install kick starter parts and the RH …
source
To see the full content, share this page by clicking one of the buttons below |
Dale I have a question what do you call the tool you used to put the clutch screws in with ( approx min 34 ). I broke mine and I am looking for a new one, when I go to the tool shop nobody knows what I am talking about. Any help would be appreciated.
Another master class Dale. Did you see Mustie1 was working on a DT360 today?
You certainly have them 2 strokes down, don't bother with 4 strokes, twice the parts, twice the weight, half the power.
That will take some getting used to. Shifter on the wrong side. Good job brother
Thanks Dale. Lovely work as usual and I'm looking forward to progress on this bike. The right side gear shift surprises me. Makes me think of my old Beezer and Trumpy back in the day.
Cheers, Peter.
Hey buddy this just now came in.
I watched a couple of flat track races and it definitely is a sport for the much younger generation.
Just a quick question for you Dale, Why were the 650 Yamaha's so difficult to start up? Seems like alot of people out there have had the same issue.
I am always impressed that Dale's suburban garage is way better equipped than most pro workshops. A major investment there!
I just love that little oil shield.Pool little slide hammer that's cool
Great quality of work as usual Dale. I'm looking forward to your progress on this one.
Best wishes, Dean.
Hot setup. I have been unimpressed with the newer silicon formulations. Why not put something like yamabond around the seal and on the cover gasket, and low strength loctite on the crank nut? Nice to seem someone working on the cool stuff. thanks
Thanks for posting
Hi guys, lets get to work!
I like the fancy piston pin puller and guide pin thingy puller , I made my own piston pin remover out of a c clamp a welder and a wrench but the one you got is much better , I hope I can get you to bore my RZ350 cylinders someday
Don't remember a right side shifter on a Yamaha ?
Good morning Dale.
Just curious Dale, is that huge lock washer standard on the 360 or was that something they put on for racing?
Man I love your show thank you Dale.
Thanks Dale , Its been a long time since I worked on a 360 . I thought for a race motor they would have put in straight cut gears . Oh well keep up the great work Dale , we will be watching .
Murray