Guide

Caterpillar weld on sprockets

Caterpillar weld on sprockets

#Caterpillar #weld #sprockets

“western truck and tractor repair”

Pulling a track frame from a D4d Cat to change a sprocket.

source

 

To see the full content, share this page by clicking one of the buttons below

Related Articles

21 Comments

  1. Good vid Warren I`ve done this before too , Only thing – 15 , Had to weld a Wishbone on a D6 in 35 below absolute BS setup , A fking welder powered by a jeep PTO OMG the govenor fluctuated so bad and it ran super hot even at that temp one guys dream build , Plus skidding tree`s to boot between fixes the guy I worked for was Hindu nice enough but penny pincher winch needed oil so I removed the plate on top grabbed the pail went to pour it in he grabbed this copper funnel with a 1/2 " spout Omg the first plop of oil at -35 it fell out of his fingers into the winch way down deep and being copper right magnet BS day Told him get another OPR. broken blade frame , Master link bolts stripped same as you had then this Get me the fk outta here . Fixed that all for a measly cheap baxtard 20 bucks he kept saying he`s broke fk it .

  2. my subs have been fine with all my suppliers of superb interest. It's not just against you Warren lots of other YouTubers are telling their subbers too to watch out for disconnection.

Leave a Reply