Lenovo
Lenovo ThinkBook 15 G4, dead, not charging, a proper
Lenovo ThinkBook 15 G4, dead, not charging, a proper hard repair.
#Lenovo #ThinkBook #dead #charging #proper
“Electronics Repair School”
UK Ebay store:
US Ebay store:
WebSite:
Patreon support:
YouTube Members:
Forum:…
source
To see the full content, share this page by clicking one of the buttons below |
Magician !!!
Amazingly cool ! You are the one, Sorin !!
Thanks for sharing
Pizza je keiva za sve hahaha
the thermal camera already tell you the exact problem from the beginning, the pd controller ๐
I instantly like Sorin's videos. No matter the content, I know there will be precious knowledge being shared here. I love your content, Sorin. I'll soon be able to send you some gifts from Brazil to thank you for all you shared with us. Thanks!
Hi Sorin. regarding the BIOS/UEFi update – you should clean that up from your SSD as it's sitting there in the boot partition and you may not have the luck next time when the BIOS gets bricked and you'll need to re-flash it.
Hi can you please tell what kind of electrical screw driver you used in the video? If you could please leave a link. Thanks.
ceau sorin unde lucuesti? am note 20 ultra sea water damaged can you recover documents?
How can you be certain chip is faulty rather than two solder balls under chip touching causing problem when u solder?
i like you when you say : we have picturrrrrre ๐
Very nice approach!
"LoowL" always means its gonna be a "Proper hard repair" ๐
The master class at his best humour and repair. Who said dodgy? It was not me! LoL. Bravo๐
Great
15:00 ๐คฃ๐คฃ๐คฃ๐คฃ Bla bla bla
When i see "….hard repair" on the description , and i see that the video is 45 minutes , i grab popcorn and enjoy ๐
Finally not a 10 minute job/video!
i love the logical progression you use to figure out the fault. lol, that bad chip is my kind of luck.
U really worked hard sir ๐
@14:58 proper reaction for what happened. LOOL
Took about 5 minutes to find the schematic and knew right away, 5v USBc power chip is the one that was burnt, and USBc controller dead. But you did it without schematic, ๐๐
thank u very much.
for sharing your knowledge for free.
that's a rare thing to find.
thank you very much.
all support.
Sorin you dont need a schematic.You are a schematic!
The proper solution is to take a pen grinder and fix in a proper way, not always is wire for a proper solutions.
๐
Very interesting, thank you for taking the time to share this great content. A hug from Granada, Spain
๐๐๐๐
better than factory!
Do the two boards have to be identical? Were the chips identical?
38:02 screws went to narnia
everytime you touch ground with testprobe the camera does a "glitch" .
Proper calibrated job!
i give up, after seeing blown track ๐
Dr. Sorin does it again ๐
perfect repair school ๐
What is the money for?
Perfect repair ๐๐๐
Thank you for the video Sorin
Good job mate ๐
Perfect craft Manship – "we have got picture, I can't believe haha LOL๐๐ !"
It goes without saying that nothing is ever won in advance. But once again Sorin, you have analyzed the problem perfectly. Thanks again for the video. ๐๐