Error 5200 (and related P07/P08 messages) on Canon G2010-class printers usually means the printhead overheated or the printer lost trust in head temperature sensing. Ink clogs and partial head failure are common triggers.
Cool-down & power cycle
- Leave the printer off 30+ minutes.
- Unplug, hold power 15 seconds.
- Power on and try a nozzle check—not a long photo print.
Ink & purge
Top tanks, run cleaning from the maintenance menu, then stop if 5200 returns immediately—repeated cleaning without progress cooks a dying head.
Deep options
Service-mode counter resets exist for technicians; wrong resets brick warranty logic. If the head is scorched, replacement—not endless cleaning—is the fix.
Safety notes
Never jab nozzles with sharp metal. Use manufacturer cleaning paths or proper purge tools.
FAQ
5200 after new ink?
Air in lines or wrong viscosity ink can overheat the head.
G2010 vs G3010?
Similar codes; confirm your exact model’s service docs.
Related on Disassembly
Photo: Unsplash. Repair steps are general guidance—model variants differ. Unplug power and follow ESD-safe practice before opening devices.
To see the full content, share this page by clicking one of the buttons below |
